![](https://cos-cdn.shuashuati.com/pipixue-wap/2020-1230-1107-56/ti_inject-812ce.png)
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem? 图
A.
管理员不能通过telnet登陆switch 1,虽然连接到switch 1的主机可以ping通路由器的Fa0 / 0接口。根据图中所给信息,假设路由器和switch 2配置正确,在switch 1上使用什么命令来解决此问题?
B.
Switch1(config)# i nterface fa0 /1
C.
itch1(config-if)# ip address 192.168.24.3.255.255.255.0
D.
Switch1 (config)# interface fa0/1
E.
itch1 (config-if)# switchport mode trunk
F.
Switch 1 (config)# i nterface fa0 /1
G.
itch1 (config-if)# duplex full
H.
itch1 (config-if)# speed 100
I.
Switch1 (config-if)# default-gateway 192.168.24.1
J.
Switch1 (config)# line con 0 K. itch1(config-line)# password cisco L. itch1 (config-line)#login